info@nelsonpaints.com +92 21 111 635 766

Wall Putty

Wall Putty

Product Description

Nelson Bold Putty ready to use. It is acrylic based superior quality water based filler for patching cracks leveling un-even rough porous cement walls.

Design Usage

Nelson Bold wall Putty formulated to fill gaps and voids of uneven surfaces. Its heavily pigmented with excellent built in bonding properties. It is suitable to fill pores, dents and imperfections of wood, concrete and related material surfaces

Technical information

Theoretical Coverage

4 – 5 m2 per kg per coat (Actual Coverage is dependent on substrate condition, application  method, application condition and finishing appearance) 

Volume Solid

45 % ± 2

Finish

Matt

Flash Point

None 

Drying Time

30 Mins (Dependent on temperature and humidity)

Recoat Interval

1 Hrs (Dependent on temperature and humidity)  

Application Method

Putty knife, Trowel, Scraper

Storage Instruction

Store in a cool shaded, well-ventilated dry area, protected from heat and direct sunlight. Container must be kept tightly closed. 

Packing

1.5 Kg , 5.5 Kg , 20 Kg

 

Surface Preparation

The surface to be painted should be clean, dry free from all loose material like efflorescence and old Flaking paint. Loose plaster, cement splashes and dust must be
thoroughly removed. New plaster / concrete must be fully cured.

Condition during Application

The temperature of the substrate should not be less then 100C and at least 30C above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate

Typical Paint System interior

Primer

Nelson water based Bold primer sealer 

1 Coats

Putty

Nelson Bold wall Putty (dependent on surface condition) 

2-3 Coats

Safety Precautions

  • Avoid contact with the skin and eyes. Wear suitable protective clothing such as goggles, dust mask and gloves. Use a barrier cream.
  • Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapors or spray.
  • This product is un-flammable but Keep away from sources of ignition and heat.
  • Paint should be stirred well before use. Replace lid of unused paint tin tightly.

Disclaimer

The information provided on this data sheet is not intended to be completed and is provided as general advice only. It is the responsibility of the user to ensure that the product is suitable for the purpose for which he wishes to use it. As we have no control over the treatment of the product, the standard of surface preparation of the substrate, or other factors affecting the use of this product, we are not responsible for its performance nor would we accept any liability whatsoever or howsoever arising from the use of this product unless specifically agreed to in writing by us. The information contained in this data sheet may be modified by us from time to time, and without notice, in the light of our experience and continuous product development.